Comments on: Twin (Single) Size Murphy Bed Hardware Kit Vertical (Upright)

By: Todd S.

Todd S. — Tue, 07 May 2024 17:43:26 +0000

All in all, it’s a really great kit. If there was one thing I would improve on would be the self tapping screws. The head of the screw doesn’t sit flush in the bracket. It seems a little too big.

By: Mike Rizzo

Mike Rizzo — Sun, 05 May 2024 15:42:16 +0000

A two day job, but was worth it. Directions were great. I didn’t need any videos but they are good to have. I was surprised when it all came together and worked perfect.

By: Rhonda A.

Rhonda A. — Fri, 22 Mar 2024 00:51:06 +0000

The videos were very helpful. They showed each step and they were easy to follow. I found that the 1/4 drill bit was not big enough tho and had to use a bigger bit to attach the nuts. High quality hardware tho.

By: Daniel B.

Daniel B. — Thu, 15 Jun 2023 11:25:32 +0000

Easy pease, if you’re handy !

By: Pete K.

Pete K. — Thu, 23 Feb 2023 00:15:38 +0000

By: Scott Brown

Scott Brown — Thu, 20 Oct 2022 17:46:07 +0000

The instructions were very easy to follow. I cut the bed parts out with a circular saw. It would have been easier if I would have had a table saw.

By: Gaye Bivins

Gaye Bivins — Tue, 12 Jul 2022 22:15:25 +0000

Nice hardware, seems heavy duty and smooth. Will send a photo after the wall unit is finished around it.

By: Anonymous

Anonymous — Thu, 07 Jul 2022 02:40:18 +0000

By: Mike

Mike — Tue, 03 May 2022 23:07:29 +0000

In reply to Mark S.. HI Mark thank you for your comments. Page 6 in the cutting guide has long been edited and fixed. I think you got an older version of our guide that probably had the typo. I checked the current copy and parts are referenced correctly. Thank you for your other recommendations. Have a great day.

By: Mark S.

Mark S. — Sun, 01 May 2022 05:11:41 +0000

On pg. 6 of the Cutting Guide document, top of page it mentions parts GD and GE I think you mean parts GC and GE.
Screwing into the face of plywood was never an issue. But screwing into the edge of the plywood ALWAYS required pre-drilling.
When drilling through plywood, the back side of the plywood will usually blow out. Clamping a piece of scrap wood on the back side helps to control this.
You should include the optional parts in the part cut list and diagrams (like the larger optional K).
The various documents have a lot of repeat pages. I would either condense them into one document or not repeat them in multiple documents.
Since making the bed frame square is very important, I would include a page on how to do that.
Your safety notes are great!
The step-by-step instructions are great!
The bed handle is not mentioned in the “parts you will need” list.